Vacuum forming (thermoforming)
also: thermoforming · pressure forming
Heating a plastic sheet and pulling it over a single-sided mold with vacuum; low tooling cost for large, simple shapes such as covers, trays, and panels.
A plastic sheet is heated until soft, draped over a mold, and pulled tight by vacuum (or pressed with air pressure in pressure forming, which captures more detail). After cooling, the part is trimmed. Molds can be wood, resin, or aluminum, so tooling is far cheaper and faster than for injection molding.
It suits large parts with fairly simple, open shapes at modest volumes: equipment covers, kiosk and machine housings, trays, packaging, and panels.
Where it bites: only one side of the part is precisely controlled, the wall thins where the sheet stretches most (corners and deep draws), bosses and fine features need secondary operations, and trimming adds cost and variation.
Founder takeaway
Consider thermoforming for large, low-volume covers and panels where injection mold tooling can't be justified.